This is a follow up on the Remington 783 after the Leatherwood scope was installed. As mentioned in the first post two handloads were picked with IMR 4064 & IMR 4831, The day was windy with 21F temps I seasoned the bore with a clean and scrub after a three round group. First off the trigger was amazing for a factory job! adjusted to 2LB, 4oz no creep just that breaking glass feel, consistent two shots touching with a flyer seemed to be the norm for IMR4064 with 40grains as a final load. Switching to IMR 4831 really tightened things up with my last group at 46grains printing a nice clover leaf 1/2″ group, these loads are with 70grain H.P. varmint pills and a quick look at the Quick Loads program had me loading up some hotter rounds with 4831. I plan to run loads up to 48.5grains to check for pressure and tighter grouping, remember this is a off the shelf factory 243 Winchester chambering with what I found to be a very short throat limiting even getting close to maximum magazine length with the tiny 70 grainers. Once back in the shop the bore was cleaned with Sweets762 copper solvent and after three treatments the barrel was copper free and ready for more rounds at the bench. First impressions of the Remington 783 are good with promising accuracy right away, light felt recoil even with a synthetic stock and a very smooth feel to the action, as for the Leatherwood scope it holds zero, clicks are positive and the range adjustable flags are a big plus!
Nice to see when a budget rifle lives up to the factory claims with out needing to shoot expensive premium ammo. Although all my brass is checked and preped with a benchrest focus. More range results to come with hopes of some chewed ragged holes.
2 responses to “Remington 783 – part 2”
Hey boss, can you send me a link to that picatinny rail on the 783?
Scope rail made by EGW, here is the link.